Pengaruh Penambahan Serbuk Kaca sebagai Subtitusi Parsial Semen pada Beton dengan Agregat Batu Apung Berlapis Acrylic

Putri, Melianty Chairunisa (2019) Pengaruh Penambahan Serbuk Kaca sebagai Subtitusi Parsial Semen pada Beton dengan Agregat Batu Apung Berlapis Acrylic. S1 thesis, Universitas Kristen Indonesia.

[img] Text (Hal_Judul_Daftar_Isi_Abstrak)
HalJudulDaftarIsiAbstrak.pdf
Available under License Creative Commons Attribution Non-commercial Share Alike.

Download (830kB)
[img] Text (BAB_I)
BABI.pdf
Restricted to Registered users only
Available under License Creative Commons Attribution Non-commercial Share Alike.

Download (452kB)
[img] Text (BAB_II)
BABII.pdf
Restricted to Registered users only
Available under License Creative Commons Attribution Non-commercial Share Alike.

Download (934kB)
[img] Text (BAB_III)
BABIII.pdf
Restricted to Registered users only
Available under License Creative Commons Attribution Non-commercial Share Alike.

Download (987kB)
[img] Text (BAB_IV)
BABIV.pdf
Restricted to Registered users only
Available under License Creative Commons Attribution Non-commercial Share Alike.

Download (914kB)
[img] Text (BAB_V)
BABV.pdf
Restricted to Registered users only
Available under License Creative Commons Attribution Non-commercial Share Alike.

Download (336kB)
[img] Text (Daftar_Pustaka)
DaftarPustaka.pdf
Restricted to Registered users only
Available under License Creative Commons Attribution Non-commercial Share Alike.

Download (111kB)
[img] Text (Lampiran)
Lampiran.pdf
Restricted to Repository staff only
Available under License Creative Commons Attribution Non-commercial Share Alike.

Download (502kB)

Abstract

Beton adalah campuran antara semen Portland, agregat halus, agregat kasar dan air dengan atau tanpa bahan tambahan yang membentuk massa padat (SNI-03-2847-2002). Teknologi beton telah berkembang sejak beberapa dekade lalu. Saat sekarang ini sudah banyak inovasi beton yang bukan hanya mengandalkan kekuatan yang tinggi namun juga massa jenis yang rendah untuk mengurangi massa bangunan sehingga resiko terkena dampak gempa pun berkurang. Oleh karena itu dalam penelitian ini digunakan serbuk kaca yang berasal dari limbah kaca untuk menambah kekuatan beton dan batu agregat ringan batu apung berlapis lem acrylic untuk mengurangi densitas dari beton tersebut Penelitian ini direncanakan mutu beton dengan kuat tekan rencana fc’ = 30 MPa Serbuk kaca diharapkan berfungsi sebagai bahan pengisi karena memiliki potensi sebagai material pozzolan. Batu apung yang digunakan dalam penelitian ini pun adalah batu apung yang telah di lapisi lem acrylic. Pelapisan ini adalah usaha yang dimaksudkan untuk melapisi batu apung karena sifatnya yang menyerap air sehingga dapat mempengaruhi faktor air semen. Dari hasil percobaan diperoleh kadar optimum serbuk kaca adalah pada persentase 10% dengan kenaikan kuat tekan sebesar 29,261 dan massa jenis beton tersebut juga mengalami penurunan sebesar 12,82% terhadap massa jenis beton normal Kata Kunci : Beton, serbuk kaca,batu apung,coating,kuat tekan,massa jenis,kuat tarik. / Concrete is a mixture of Portland cement, fine aggregate, coarse aggregate and air with or without additives which form a solid mass (SNI-03-2847-2002). Concrete technology has developed since a few decades ago. Nowadays there have been many concrete launches that not only rely on high strength but also low mass types to reduce the mass of the building so that the risk caused by the earthquake is reduced. Therefore, in this study used glass powder derived from glass waste to add concrete and lightweight aggregate pumice stone equipped with acrylic glue to reduce the density of the concrete. This research uses concrete with compressive strength plan fc '= 30 MPa Glass powder is expected to be used as a filler because it has potential as a pozzolanic material. Pumice used in this study is pumice that has been coated with acrylic glue. This coating serves to coat the pumice because it connects cement air. From the experimental results obtained optimal levels of glass powder at a percentage of 10% with an increase in compressive strength of 29,261 and the density of concrete also increased by 12.82% of normal concrete density Keywords: Concrete, glass powder, pumice, coating, compressive strength, density, tensile strength.

Item Type: Thesis (S1)
Contributors:
ContributionContributorsNIDN/NIDKEmail
Thesis advisorSimanjuntak, PinondangUNSPECIFIEDUNSPECIFIED
Subjects: TECHNOLOGY
Divisions: FAKULTAS TEKNIK > Teknik Sipil
Depositing User: Mr Novan Arbi
Date Deposited: 02 Oct 2024 08:03
Last Modified: 02 Oct 2024 08:03
URI: http://repository.uki.ac.id/id/eprint/17301

Actions (login required)

View Item View Item